MIL-DTL-22529/1C
6.4 When installing grommets, the gap (joint) shall be at the top of the cutout hole. Avoid locating joints in the lower
half of the cutout hole.
7. U.S. Patent No's 4,769,966 and 5,343,669 expire 20 April 2007 and 6 July 2012 respectively. Other U.S. and
foreign patents pending. The Government does not have a royalty-free license.
8 The military detail part number, single-digit dash variation, and manufacturer's identification to be printed and
repeated on the surface of the grommet at least every 10.6 in. per Fig 1.
9 Changes from previous issue: The margins of this specification are marked with vertical lines to indicate where
changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability
whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of
this document based on the entire content irrespective of the marginal notations and relationship to the last issue.
Custodians:
Preparing Activity:
Navy - AS
DLA-IS
Air Force - 99
(Project 5325-0400-01)
Review Activities:
Air Force - 82
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business