INCH-POUND
MIL-DTL-45916C
11 August 2014
SUPERSEDING
MIL-I-45916B
24 July 1975
DETAIL SPECIFICATION
INSERT, SCREW THREAD - THREAD
CUTTING AND THREAD FORMING
This specification is approved for use by all Departments and Agencies of the Department of
Defense.
1. SCOPE
1.1 Scope. This specification covers solid bushing screw thread inserts having thread cutting
and thread forming external threads (see 6.1).
1.2 Classification. Inserts shall be furnished in the following types, as specified (see 6.2).
Type I - Thread cutting, regular wall.
Type IA - Thread cutting, thin wall.
Type II - Thread forming.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they must
meet all specified requirements of documents cited in sections 3 and 4 of this specification,
whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications and standards
form a part of this document to the extent specified herein. Unless otherwise specified, the
issues of these documents are those cited in the solicitation or contract.
FEDERAL STANDARDS
FED-STD-H28
Screw-Thread Standards for Federal Service
Comments, suggestions, or questions on this document should be addressed to Defense
Supply Center Philadelphia (DSCP), ATTN: DSCP-NASA, 700 Robbins Avenue, Philadelphia,
PA 19111-5096 or e-mail to dscpg&ispecomments@dla.mil . Since contact information can
change, you may want to verify the currency of this address information using the ASSIST
Online database at https://assist.dla.mil .
AMSC N/A
FSC 5325
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business