MIL-DTL-10884H
4.2.2 In-process inspection. Inspection of subassemblies shall be made to ascertain that
construction details which cannot be examined in the finished product are in accordance with
specified requirements. The Government reserves the right to exclude from consideration for
acceptance, any material or service for which in-process inspection has indicated
nonconformance.
a. Cleaning of button cap shells prior to enameling (when applicable) is in conformance to
3.4.2.2.2 and 3.4.5.
b. Nickel undercoating prior to chrome plating (when applicable) is in conformance to 3.4.4.1
and 3.4.4.2.
4.2.3 End item visual inspection. The end items shall be examined in accordance with ASTM
F1470 for the characteristics listed in table 1, as applicable. Sample size shall be in accordance
with size "B" requirements. The fasteners shall be examined for the following characteristics:
Finish :Not finished; color or finish is not as specified, unless excepted (e.g., glossiness of
head or stud body; scratch, dig, or abrasion exposing bare metal; areas of corrosion; enamel
coating not uniform over the top and visible portion of the edge of the shell of the button cap;
enamel coating has sags, runs or streaks, or is not smooth).
Design, construction and workmanship, general (applicable to all components and
assemblies): Any component missing, any component not fabricated of the applicable referenced
materials; not fabricated as specified; not clean ( i.e., evidence of oil, grease or dirt); sharp edge
or burr; puncture, malformation, deformation or fracture.
Assembling data: Missing, as applicable; incomplete or illegible.
Marking (identification): Missing, incomplete, illegible, misspelled or incorrect; not
permanent.
4.2.4 End item dimensional examination. The end items shall be examined in accordance
with ASTM F1470 for conformance to the dimensions specified on the drawings that can be
determined on the end item without damaging or disassembling the end items. Any dimensions
not within the specified tolerance shall be classified as a defect. Sample size shall be in
accordance with size "B" requirements.
4.2.5 End item testing. The end items shall be tested for the characteristics listed in Table I.
The methods of testing specified in FED-STD-191 wherever applicable and as listed in Table I
shall be followed. Sample size shall be in accordance with ASTM F1470 size "A" requirements.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business