MIL-DTL-27426C
SOCIETY OF AUTOMOTIVE ENGINE ERS
AS3215
-
Ring, Retaining-Spiral, Internal, Heavy Duty, CRES
AS3216
-
Ring, Retaining-Spiral, External, Heavy Duty, CRES
AS3217
-
Ring, Retaining-Spiral, Internal, Light Duty, CRES
AS3218
-
Ring, Retaining-Spiral, External, Light Duty, CRES
AS3219
-
Ring, Retaining, Spiral, Minimum Distortion,
Dimensional and Acceptance Standard for
SAE 1070-1090
- Steel, Carbon, Strip, Cold Rolled, Hardened and
Tempered, Spring Quality
SAE AMS 5866
- Steel, Corrosion Resistant, Flat Wire 18Cr 9.0 Ni
(SAE 30302) Spring Temper (UNS S30200)
(Application for copies should be addressed to the Society of Automotive
Engineers, 400 Commonwealth Dr., Warrendale, PA
15096-0001).
(Non-Government Standards and other publications are normally available from the
organizations that prepare or distribute the documents. These documents also may be
available in or through libraries or other informational services).
2.4 Order of precedence. In the event of a conflict between the text of this
document and the references cited herein (except for related associated specifications,
specification sheets, or MS standards), the text of this document takes precedence.
Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3.
REQUIREMENTS
3.1 Materials. Material used in the manufacture of retaining rings shall be
either carbon steel, corrosion-resisting steel, or copper-beryllium alloy as specified
in the contract or purchase order (see 6.2).
3.1.1 Carbon steel. Carbon steel used in the manufacture of retaining rings
shall conform to the requirements of SAE 1070-1090, AISI Grade designation C1070
through C1090 inclusive.
3.1.2 Corrosion-resisting steel . Corrosion-resisting steel used in the
manufacture of retaining rings shall conform to the requirements of AMS 5866.
3.1.3 Copper-beryllium alloy . Copper-beryllium alloy used in the manufacture of
retaining rings shall conform to ASTM B197, alloy number C17200.
3.2 Physical requirements. Retaining rings shall conform to the appropriate
physical requirements specified in 3.2.1 through 3.2.3 for the type, material, and
size of ring specified (see 6.2).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business