MIL-DTL-22529D (AS)
MUNSELL COLOR COMPANY, INC.
Munsell Book of Color
(Copies of the Munsell Book of Color may be obtained from the Munsell Color
Company, Inc., 2441 N. Calvert Street, Baltimore, MD
21218-5204.)
2.4 Order of precedence. In the event of a conflict between the text of
this document and the references cited herein the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
3.
REQUIREMENTS
3.1 Specification sheets. The individual grommet requirements shall be
in accordance with MS21266 or MIL-DTL-22529/1 and MIL-DTL-22529/2. In the
event of any conflict between requirements of this specification and the
Specification Sheets, the latter shall govern.
3.2
Performance.
3.2.1 Dielectric withstanding voltage (dielectric strength). There shall
be no disruptive discharge, nor any deterioration of the grommet when
subjected to Dielectric Strength Test specified in 4.2.9. This requirement
shall be modified per MIL-DTL-22529/1 and MIL-DTL-22529/2.
3.2.2 Immersion. The grommets shall show no evidence of cracking, pitting
or material failure, after subjection to the immersion test specified in
4.2.5.
3.2.3 Temperature cycling. The grommets shall show no evidence of
cracking, pitting or material failure, after subjection to the temperature
test specified in 4.2.6.
3.2.4 High temperature and load deformation. Dimension "T", shown on
Figure 2 (Section "AA"), shall be not less than one-half that of an untested
grommet of same type and size upon completion of the high temperature and load
deformation test (4.2.7)
3.2.5 Vibration. The grommets shall show no evidence of cracking, pitting
or material failure, after subjection to the vibration test specified in
4.2.8.
3.3 Color. The nylon grommets shall be white and shall have a value not
less than 9.0 as specified by the Munsell Book of Color. The
polytetrafluoroethylene (TFE) shall be neutral color (light gray) having a
chroma not greater than 1.0 and having a value not less than 6.0 or greater
than 8.0 as defined by the Munsell Book of Color. The composite Grommet type
MIL-DTL-22529/1 shall be brown per FED-STD-595, color number 10075, and the
MIL-DTL-22529/2 shall be black.
3.4 Identification of Product. Each grommet shall have the MS part number
and the manufacturer's identification on the outer surface. Nylon and TFE
grommet types will be molded on the outer surface. The composite grommet type
printed.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business